Remove Intake Air Connector

(a) Disconnect the air valve hose from intake air connector.

<b) Loosen the clamp and remove the two bolt. 4c) Remove the intake air connector.

6. REMOVE IGNITION COIL COVER

(a) Remove the oil filler cap.

(b) Remove the five nuts and ignition coil cover.

7. REMOVE IGNITION COIL WITH BRACKET

(a) Disconnect the connector and ground strap.

(c) Remove the No.1 and No.2 high-tension cords from ignition coil and clamp.

(d) Remove the ignition coil with bracket and high-tension cords.

(e) Remove the No.1 and No.2 high-tension cords from spark plugs.

8. REMOVE CYLINDER HEAD COVERS

(a) Remove the accelerator link.

(b) Disconnect the No.3 PCV hose.

(c> Remove the cylinder head covers.

9. MEASURE VALVE CLEARANCE (See step 5 on pages EM-8. 9)

10. ADJUST VALVE CLEARANCE (See step 6 on pages EM-9, 10)

11. RECHECK VALVE CLEARANCE

12. INSTALL CYLINDER HEAD COVERS (See step 4 on pages EM-55, 56)

13. INSTALL IGNITION COIL WITH BRACKET

(a) Install the No. 1 and No.2 high-tension cords to spark plugs.

(b) Install the ignition coil with bracket and high-tension cords.

(c) Install the No.1 and No.2 high-tension cords to ignition coil and clamp.

IW6249

(d) Install and torque the nut. Torque: 55 kg-cm (48 in-lb, 5.4 N-m) HINT: Oo not over tighten the nut.

(e) Connect the ground strap and connector.

14. INSTALL IGNITION COIL COVER

(a) Install the ignition coil cover with five nuts.

(b) Install the oil filler cap.

15. INSTALL INTAKE AIR CONNECTOR

(a) Install the intake air connector to throttle body.

(b) Install and tighten the two bolts.

(c) Tighten the clamp.

(d) Connect the air valve hose to intake air connector.

16. INSTALL PCV PIPE WITH HOSES

(a) Install the PCV pipe with hoses to throttle body and cylinder head covers.

(b) Install and tighten the two bolts.

(c) Connect the No.4 PCV hose to the PCV pipe.

(d) Connect the oxygen sensor wire to the two clamps.

17. INSTALL ISC PIPE

(a) Install the ISC pipe with two bolts. <b) Connect the six hoses to ISC pipe.

18. CONNECT FOLLOWING CABLES AND ROD:

(b) Accelerator rod

(c) Accelerator link w/ cable

19. INSTALL NO.1 AIR CLEANER HOSE

Was this article helpful?

0 0

Post a comment