Remove Piston Rings

(a) Using a piston ring expander, remove the compression rings.

<b) Remove the two side rails and oil ring expander by hand.

HINT: Arrange the rings in correct order.

3. DISCONNECT CONNECTING ROD FROM PISTON

(a) Using needle-nose pliers, remove the snap rings from the piston.

(b) Gradually heat the piston to approx. 60°C (140°F).

(c> Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

HINT:

• The piston and pin are a matched set.

• Arrange the pistons, pins, rings, connecting rods and bearings in correct order.

I Mi9?fl

IM4V4S

Was this article helpful?

0 0

Post a comment