Replacement Of Oil Seals

NOTE: There are two methods (A and B) of oil seal replacement.

1. REPLACE CRANKSHAFT FRONT OIL SEAL

A. If the timing case is removed from the cylinder block:

(a) Using a screwdriver and hammer, tap out the oil seal.

(b) Using SST and a hammer, tap in a new oil seal. SST 09214-60010 and 09506-35010

(c) Apply MP grease to the oil seal lip.

Block Seal Toyota Supra

B. If the timing case is installed to the cylinder block:

(a) Using SST, remove the oil seal. SST 09308 55010

IWJ'il

IW.inMWM

(b) Apply MP grease to a new oil seal lip.

(c) Using SST and a hammer, tap in the oil seal. SST 09214-60010 and 09506-35010

2. REPLACE CRANKSHAFT REAR OIL SEAL

A. If the rear oil seal retainer is removed from the cylinder block:

(a) Using a screwdriver and hammer, tap out the oil seal.

(b> Using SST and a hammer, tap in a new oil seal. SST 09223-41020

(c) Apply MP grease to the oil seal lip.

B. If the rear oil seal retainer is installed to the cylinder block:

(a) Using a knife, cut off the lip of the oil seal as shown.

<b) Using a screwdriver, pry out the oil seal.

NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip.

<c) Check the oil seal lip contact surface of the crankshaft for cracks or damage.

(d) Apply MP grease to a new oil seal lip.

(e) Using SST and a hammer, tap in the oil seal. SST 09223-41020

3. REPLACE OIL PUMP DRIVE SHAFT OIL SEAL

A. If the timing belt case is removed from the cylinder block:

(a) Using a screwdriver and hammer, tap out the oil seal.

(b) Using SST and a hammer, tap in a new oil seal. SST 09214-41010

(c> Apply MP grease to the oil seal lip.

B. If the timing belt case is installed to the cylinder block:

(a) Using a knife, cut off the lip of the oil seal as shown.

(b) Using a screwdriver, pry out the oil seal.

NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip.

(c) Check the oil seal lip contact surface of the pump drive shaft for cracks or damage.

(d) Apply MP grease to a new oil seal lip.

(e) Using SST and a hammer, tap in the oil seal. SST 09214 41010

0 -1

Responses

  • cettina
    How to fix a Toyota 2002 rear crank shaft oil seal?
    8 years ago

Post a comment