Replacement Of Reverse Restrict Pin Remove Reverse Restrict

(a) Using SST, remove the screw plug. SST 09313-30021

(b) Using a pin punch and hammer, drive out the slotted spring pin.

(c) Pull off the lever housing and slide out the shaft.

2. INSPECT REVERSE RESTRICT PIN

Turn and push the reverse restrict pin by hand while applying direction.

3. INSTALL REVERSE RESTRICT PIN

(a) Install the lever housing.

(b) Using a pin punch and hammer, drive in the slotted spring pin as shown.

(c) Apply liquid sealer to the plug.

Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent

(d) Install and torque the screw plug. Torque: 250 kg-cm (18 ft-lb, 25 N-m)

Was this article helpful?

0 0

Post a comment