How To Remove Tems Supra

f Al 773

(e) Turn the steering wheel 1/10 — 1/8 turn to the right from a straightaway position and check that the F indicator flash and the S light goes out.

f Al 773

(f) Return the steering wheel to right from the straightaway position and then 1/10 — 1/8 turn to the left and check that the S indicator light flash and the F light goes out. If operation is not as specified in (e) and (f) inspect for the cause.

2. INSPECT STEERING SENSOR ASSEMBLY

(a) Turn the ignition switch on, and measure the voltage between steering sensor connector terminals 1 and 2.

Standard voltage: 3.5 - 4.2 volts

U4 I

(b) Measure the voltage between steering sensor connec tor terminals 3. 4 and 2 wheel slowly turning the steering wheel.

If not as shown above, either the circuit between the computer and steering sensor is shorted or the steering sensor is faulty.

3. REMOVE STEERING SENSOR AND DISC (See page SR-7)

4. INSPECT STEERING SENSOR AND DISC

(a) Check that there is no foreign matter in the groove of the sensor. If necessary, clean out the groove with a soft cloth.

(b) Check that the sensor disc is not bent and that on dirt or foreign matter are adhering.

5. INSTALL STEERING SENSOR AND DISC (See page SR-12)

Was this article helpful?

0 0

Responses

  • Natalie
    How to remove tems supra?
    4 years ago

Post a comment