Dtc Summary

DTCs

Monitoring Items

Malfunction Detection Conditions

Trouble Areas

Detection Timings

Detection Logic

Purge VSV (Vacuum Switching Valve) stuck open

Leak detection pump creates negative pressure (vacuum) in EVAP system and EVAP system pressure measured. 0.02 inch leak criterion measured at start and at end of leak check. If stabilized pressure higher than [second 0.02 inch leak criterion x 0.2], ECM determines that purge VSV stuck open

• Connector/wire harness

• Canister pump module

• Leakage from EVAP system

While ignition Switch OFF

2 trip

P0441

Purge VSV stuck closed

After EVAP leak check performed, purge VSV turned ON (open), and atmospheric air introduced into EVAP system. 0.02 inch leak criterion measured at start and at end of leak check. If pressure does not return to near atmospheric pressure, ECM determines that purge VSV stuck closed

• Connector/wire harness

• Canister pump module

• Leakage from EVAP system

While ignition Switch OFF

2 trip

Purge flow

While engine running, following conditions successively met:

• Negative pressure not created in EVAP system when purge VSV turned ON (open)

• EVAP system pressure change less than 0.5 kPa (3.75 mmHg) when vent valve turned ON (closed)

• Atmospheric pressure change before and after purge flow monitor less than 0.1 kPa (0.75 mmHg)

• Connector/wire harness

• Leakage from EVAP line

(Purge VSV - Intake manifold)

• ECM

While engine running

2 trip

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment