Es

(a) Preconditions

The monitor will not run unless:

(b) Drive Pattern

(1) Connect a intelligent tester or OBD II scan tool to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the tester or scan tool ON.

(5) Start the engine and warm it up.

(6) Drive the vehicle at between 55 mph and 70 mph (88 km/h and 113 km/h) for at least 10 minutes.

(c) Monitor Status

(1) Check the Readiness Monitor status displayed on the tester or scan tool.

(2) If the status does not switch to COMPL (complete), extend the driving time.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment