Inspect Crankshaft Position Sensor

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance between the terminals. Standard:

1850 to 2450 Q at 20°C (68°F) If the result is not as specified, replace the crankshaft position sensor.

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt. Torque: 10 N*m (102 kgf*cm, 7.4 in.*lbf)

(c) Connect the crankshaft position sensor connector.

2. INSTALL COOLER COMPRESSOR ASSEMBLY

(a) Install the cooler compressor assembly with the 4 bolts.

(b) Connect the cooler compressor assembly connector.

(c) Install the suction hose sub-assembly with the bolt. Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

3. INSTALL GENERATOR ASSEMBLY (See page CH-13)

4. INSTALL FAN SHROUD (See page CO-20)

5. INSTALL V-BANK COVER (See page ES-416)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

DTC

P0604

Internal Control Module Random Access Memory (RAM) Error

DTC

P0606

ECM / PCM Processor

DTC

P0607

Control Module Performance

DTC

P0657

Actuator Supply Voltage Circuit / Open

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment