2006 Toyota Tacoma Engine Under Cover Assembly Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for 4WD and Pre-Runner)

3. DRAIN ENGINE COOLANT (See page CO-3)

4. REMOVE INTAKE AIR CONNECTOR (See page ES-452)

5. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY (See page ES-453)

6. DISCONNECT FUEL HOSE (See page FU-11)

7. DISCONNECT FUEL HOSE NO.2 (See page FU-11)

8. REMOVE INTAKE MANIFOLD

(a) Disconnect the fuel vapor feed hose from the VSV.

(b) Disconnect the vacuum hose.

(c) Remove the bolt, then remove the clamp bracket.

(d) Disconnect the water by-pass hose No. 2.

(e) Disconnect the ventilation hose No. 3.

(f) Disconnect the VSV connector.

(g) Disengage the engine wire harness clamp.

(h) Disconnect the compressor magnetic clutch connector. (w/ AIR CONDITIONING)

(i) Disengage the wire harness clamp.

(j) Remove the bolt and harness clamp bracket.

(k) Disconnect the 3 connectors. (l) Remove the nut shown in the illustration. (m) Disconnect the engine wire harness from the relay block.

(n) Remove the 5 bolts and 2 nuts, then remove the intake manifold.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment