Standard Resistance Check for open

(d) Reconnect the ECM connector.

(e) Reconnect the CKP sensor connector.

REPAIR OR REPLACE HARNESS OR CONNECTOR

Tester Connections

Specified Conditions

NE+ (C5-1) - NE+ (E6-21)

Below 1 Q

NE- (C5-2) - NE- (E6-20)

Standard Resistance (Check for short)

Tester Connections

Specified Conditions

NE+ (C5-1) or NE+ (E6-21) - Body ground

10 kQ or higher

NE- (C5-2) or NE- (E6-20) - Body ground

CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR)

(a) Check the CKP sensor installation. OK:

Sensor is installed correctly.

TIGHTEN SENSOR

CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE(CRANKSHAFT))

(a) Check the teeth of the sensor plate. OK:

Sensor plate does not have any cracks or deformation.

REPLACE CRANKSHAFT POSITION SENSOR PLATE

REPLACE ECM

1GR-FE ENGINE CONTROL SYSTEM - CAMSHAFT TIMING OIL CONTROL VALVE

ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

ON-VEHICLE INSPECTION

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment