System Ok

CRANKSHAFT POSITION SENSOR REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner)

3. REMOVE FAN AND GENERATOR V BELT (W/ AIR CONDITIONING) (See page EM-5)

4. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING) (See page EM-21)

5. REMOVE IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING)

(a) Remove the 5 bolts, then remove the idle pulley with bracket.

6. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.

(b) Remove the bolt, then remove the crankshaft position sensor.

INSPECTION

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment