Torque Nm kgfcm ftlbf

(d) Connect the 6 fuel injector connectors.

9. CONNECT NO.2 FUEL PIPE SUB-ASSEMBLY

10. CONNECT NO.1 FUEL PIPE SUB-ASSEMBLY (See page FU-17)

11. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Set a new gasket to the RH cylinder head with the oval shape facing forward.

NOTICE:

Be careful of the installation direction.

(b) Install the exhaust manifold with the 6 nuts. Tighten the nuts uniformly in several steps.

(c) Connect the air fuel ratio sensor connector.

12. INSTALL MANIFOLD STAY

(a) Install the manifold stay with the 3 bolts. Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)

13. INSTALL FRONT EXHAUST PIPE ASSEMBLY

14. INSTALL NO.1 COOL AIR INLET

(a) Install the cool air inlet with the 2 bolts. Torque: 12 N*m (122 kgf*cm, 9.0 ft.*lbf)

15. INSTALL CHAIN TENSIONER SLIPPER

16. INSTALL NO.1 CHAIN TENSIONER ASSEMBLY (See page EM-27)

17. INSTALL CHAIN SUB-ASSEMBLY

18. INSTALL TIMING CHIAN OR BELT COVER SUB-ASSEMBLY

LU-38

19. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)

20. INSTALL POWER STEERING LINK ASSEMBLY

21. INSTALL BATTERY

22. ADD ENGINE OIL (See page LU-5)

23. ADD ENGINE COOLANT (See page CO-3)

24. ADD DIFFERENTIAL OIL (for 4WD)

25. INSPECT DIFFERENTIAL OIL (for 4WD) (See page DF-8)

26. ADD POWER STEERING FLUID

27. BLEED POWER STEERING FLUID (See page PS-2)

28. CHECK FOR ENGINE OIL LEAKAGE

29. CHECK FOR ENGINE COOLANT LEAKAGE (See page CO-4)

30. CHECK FOR FUEL LEAKAGE

31. CHECK FOR EXHAUST GAS LEAKAGE

32. CHECK FOR POWER STEERING FLUID LEAKAGE

33. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

34. INSPECT IGNITION TIMING (See page EM-1)

35. INSPECT ENGINE IDLING SPEED (See page EM-2)

37. REMOVE COMPRESSION (See page EM-2)

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment