Torque Nm kgfcm ftlbf

Connect the engine wire harness to the relay block. Install the nut shown in the illustration. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

Connect the 3 connectors.

Install the harness clamp bracket with the bolt. Torque: 8.2 N*m (84 kgf*cm, 73 in.*lbf)

Engage the wire harness clamp.

Connect the compressor magnetic clutch connector.

(w/ AIR CONDITIONING)

Engage the engine wire harness clamp.

Connect the VSV connector.

(k) Connect the ventilation hose No. 3.

(l) Connect the water by-pass hose No. 2.

(m) Install the clamp bracket with the bolt. Torque: 19 N*m (194 kgf*cm, 14 in.*lbf)

(n) Connect the vacuum hose.

(o) Connect the fuel vapor feed hose to the VSV.

3. CONNECT FUEL HOSE (See page FU-17)

4. CONNECT FUEL HOSE NO.2 (See page FU-17)

5. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY (See page ES-454)

6. INSTALL INTAKE AIR CONNECTOR (See page ES-455)

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. ADD ENGINE COOLANT (See page CO-3)

9. CHECK FOR ENGINE COOLANT LEAKAGE (See page CO-2)

10. CHECK FOR FUEL LEAKAGE

11. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner)

THROTTLE BODY COMPONENTS

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment