Typical Enabling Conditions

EVAP key-off monitor runs when all of following conditions met

-

Atmospheric pressure

70 to 110 kPa (525 to 825 mmHg)

Battery voltage

10.5 V or higher

Vehicle speed

4 km/h (2.5 mph) or less

Ignition switch

OFF

EVAP control system pressure sensor

Not detected

Purge VSV

Not operated by scan tool

Vent valve

Not operated by scan tool

Leak detection pump

Not operated by scan tool

Both of the following conditions 1 and 2 are met before key off

-

1. Duration that vehicle has been driven

5 minutes or more

2. EVAP purge operation

Performed

ECT

4.4 to 35°C (40 to 95°F)

IAT

4.4 to 35° C (40 to 95° F)

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment