New cables does not habe a cable stopper staked.

(c) Bend the cable so that there is a radius of about 200 mm (7.87 in.).

(d) Pull the inner cable lightly nutil a slight resistance is felt, and hold it there.

(e) Stake the stoppe, 0.8-1.5 mm (0.031-0.059 in.) from the end of outer cable.


Installation is in the reverse order of the previous steps.


• After installation, adjust the throttle cable (See page AX-2 ).

• Test drive the vehicle.

Adaptor / AKi 0

Plate Washer O-Ring AT2709

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment