Inspection Procedure

(a) Remove the door trim and service hole cover.

(b) Disconnect the door key lock and unlock switch connector.

CHECK:

Check continuity between terminals 1, 3 and 2 or door key lock and unlock switch connector, when door key lock and unlock switch is turned to the lock side, unlock side and not turned. OK:

Switch position

Lock side

Unlock side

Tester connection

Specified condition

Continuity

Continuity

No continuity

Replace door key lock and unlock switch.

2 Check harness and connectors between ECU and switch, switch and body ground (See page IN-26 ).

Proceed to next circuit inspection shown on matrix chart (See page DI-196 ).

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment