Inspection Procedure

K16tr11 Gap

PREPARATION:

(a) Disconnect the high-tension cord or ignition coil.

(b) Remove the spark plug. CHECK:

Check plug type.

Check for carbon deposits on electrode. Check electrode gap.

(1) Twin ground electrodes type. Recommended spark plug:

ND: K16TR11 NGK: BKR5EKB-11

(2) No large carbon deposit present. Not wet with gasoline or oil.

(3) Electrode gap: 1.0 - 1.1 mm (0.039 - 0.043 in.) PREPARATION:

(a) Install the spark plug to the high-tension cord or ignition coil.

(b) Disconnect the injector connector.

(c) Ground the spark plug. CHECK:

Check if spark occurs while engine is being cracked. NOTICE:

To prevent excess fuel being injected from the injectors during this test, do not crank the engine for more than 5 -10 seconds at a time. OK:

Spark jumps across electrode gap.

Replace or check ignition system (See page IG-1 ).

PREPARATION:

(a) Remove the lower finish panel.

(b) Turn the ignition switch ON. CHECK:

Measure the voltage between applicable terminals of the ECM

connector and the body ground.

Check for open and short in harness and connector between injector and ECM (See page IN-26).

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment