Inspection Procedure

Reference: INSPECTION USING OSCILLOSCOPE

Refer to page DI-60 .

2 Check for open and short in harness and connector between ECM and camshaft position sensor (See page IN-26 ).

3

Inspect sensor installation

NG^

Tighten the sensor.

OK

Check and replace ECM (See page IN-26 ).

DI95P-01

DTC

P0401

Exhaust Gas Recirculation Flow Insufficient

Detected

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment