Installation

1. INSTALL COMPRESSOR WITH 4 MOUNTING BOLTS Torque: 25 Nm (250 kgfcm, 18 ftlbf)

2. INSTALL DRIVE BELT (See page AC-20)

3. CONNECT 2 HOSES TO COMPRESSOR SERVICE VALVES Torque: 10 Nm (100 kgfcm, 7 ftlbf)

HINT:

Lubricate 2 new O-rings with compressor oil and install the tubes.

4. CONNECT MAGNETIC CLUTCH LEAD WIRE TO WIRING HARNESS

5. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY

6. EVACUATE AIR FROM REFRIGERATION SYSTEM AND CHARGE SYSTEM WITH REFRIGERANT Specified amount:

7. INSPECT FOR LEAKAGE OF REFRIGERANT

Using a gas leak detector, check for leakage of refrigerant. If there is leakage, check the tightening torque at the joints.

8. INSPECT A/C OPERATION

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment