Inspect Map Light Assembly

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below. Standard Resistance

Tester Connection


Specified Condition

1 - 2


10 kQ or higher

1 - 2

Drivers switch ON

Below 1 Q

1 - 2

Passengers switch OFF

Below 1 Q

If the result is not as specified, replace the map light.

(b) Check the light operation.

(1) Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 2, then check that the light illuminates. standard:

Light illuminates. If the light does not illuminate, replace the bulb.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment