Inspect Outer Rear View Mirror Assembly Lh

EZ Battery Reconditioning Method

How to Recondition a Battery

Get Instant Access

(a) Check the operation.

(1) Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror. Standard

Measurement Condition

Mirror Assembly Operation

Battery positive (+) - Terminal 5 (MV) Battery negative (-) - Terminal 4 (COM)

Turns upward

Battery negative (-) - Terminal 5 (MV)

Turns downward

Battery positive (+) - Terminal 3 (MH) Battery negative (-) - Terminal 4 (COM)

Turns left

Battery negative (-) - Terminal 3 (MH)

Turns right

If the result is not as specified, replace the outer rear view mirror.

Outer Rear View Mirror Styling

2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

(a) Check the operation.

(1) Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror. Standard

Measurement Condition

Mirror Assembly Operation

Battery positive (+) - Terminal 5 (MV) Battery negative (-) - Terminal 4 (COM)

Turns upward

Battery negative (-) - Terminal 5 (MV)

Turns downward

Battery positive (+) - Terminal 3 (MH) Battery negative (-) - Terminal 4 (COM)

Turns left

Battery negative (-) - Terminal 3 (MH)

Turns right

If the result is not as specified, replace the outer rear view mirror.

INSTALLATION

1. INSTALL OUTER MIRROR COVER

(a) Engage the claw on the lower part of the mirror cover.

(b) Engage the claw on the upper part of the mirror cover and install it.

(c) After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.

NOTICE:

If there is a gap between the cover and the mirror body, it may cause noise during driving.

(d) Engage the 2 claws of the outer rear view mirror.

(e) Engage the 2 clips and install the mirror.

2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

(a) Engage the claw, then install the outer rear view mirror with the 3 nuts.

(b) w/ Power mirror: Connect the connector.

3. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY (See page ED-51)

4. INSTALL FRONT ARMREST BASE PANEL UPPER (w/ Power Window) (See page ED-53)

5. INSTALL FRONT ARMREST BASE PANEL UPPER (w/ o Power Window) (See page ED-74)

6. INSTALL DOOR ARMREST COVER (See page ED-53)

7. INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See page ED-75)

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

MI-17

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment