Inspection

1. INSPECT HAZARD WARNING SIGNAL SWITCH

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below. Standard Resistance

Tester Connection

Condition

Specified Condition

1 - 4

OFF

10 kQ or higher

1 - 4

ON

Below 1 Q

2 - 3

Illumination circuit

Below 1 Q

If the result is not as specified, replace the hazard warning signal switch. (b) Check the illumination operation.

(1) Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 2, then check that the illumination illuminates. Standard:

Illumination illuminates. If the illumination does not illuminate, replace the hazard warning signal switch.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment