Installation

1. INSTALL FUEL SENDER GAUGE ASSEMBLY

(a) Install the fuel sender gauge onto the fuel suction with pump and gauge tube.

(b) Connect the fuel sender gauge connector.

2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (See page FU-33)

3. INSTALL FUEL PUMP GAUGE RETAINER (See page FU-33)

4. CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY (See page FU-33)

5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY (See page FU-34)

6. INSTALL REAR FLOOR SERVICE HOLE COVER (See page FU-34)

7. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type) (See page SE-84)

8. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See page SE-85)

9. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) (See page SE-85)

10. INSTALL DECK FLOOR BOX (for 60/40 Split Seat Type) (See page SE-85)

11. INSTALL DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type) (See page IR-83)

12. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type) (See page IR-83)

13. INSTALL REAR SEAT CUSHION COVER PAD (for Hold Down Seat Type) (See page SE-123)

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

15. CHECK FOR FUEL LEAK (See page FU-7)

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment