Ip

FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY

NO. 2 HEATER TO REGISTER DUCT

NO. 1 HEATER TO REGISTER DUCT

NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

NO. 1 HEATER TO REGISTER DUCT

NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

INSTRUMENT PANEL CUSHION

INSTRUMENT PANEL CUSHION

UPPER INSTRUMENT PANEL

NO. 1 INSTRUMENT PANEL CUSHION

UPPER INSTRUMENT PANEL

NO. 1 INSTRUMENT PANEL CUSHION

NO. 2 INSTRUMENT PANEL CUSHION

NO. 3 INSTRUMENT PANEL CUSHION

NO. 3 INSTRUMENT PANEL CUSHION

B132378E01

REMOVAL

HINT:

Use the same procedure for both the RH and LH sides.

1. BOLTS, SCREWS AND NUTS TABLE

HINT:

All bolts, screws and nuts relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.

mm(in.) (L=Length)

Code

Shape

Code

Shape

Code

Shape

93568-15014

93568-55014

V-

90105-08120 91643-80820

B118994E01

B118994E01

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See page ME-138)

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See page ME-138)

5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See page ME-138)

6. REMOVE INSTRUMENT CLUSTER FINISH PANEL (See page ME-139)

7. REMOVE COMBINATION METER ASSEMBLY (See page ME-139)

8. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

(a) Separate the front door opening trim weatherstrip.

9. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

(a) Separate the front door opening trim weatherstrip.

10. REMOVE FRONT PILLAR GARNISH RH (See page IR-18)

11. REMOVE FRONT PILLAR GARNISH LH (See page IR-19)

12. REMOVE GLOVE COMPARTMENT DOOR

ASSEMBLY

(a) Disengage the claw and separate the 2 glove compartment door stoppers from the glove compartment door.

(b) Slightly flex the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.

(c) Pull the glove compartment door assembly out horizontally to disengage the hinge portion and remove the glove compartment door. NOTICE:

Pull the glove compartment door out horizontally, otherwise, installation failure caused by excessive play around the hinge portion will result.

13. REMOVE UPPER INSTRUMENT PANEL SUBASSEMBLY

(a) Slide the slider and disconnect the passenger airbag connector.

(b) Disconnect the clamp.

(c) Remove the 2 <C> bolts and 2 <B> screws.

(d) Disengage the 7 clips by lifting the rear side of the instrument panel up.

(e) While lifting the instrument panel, slide it toward the rear of the vehicle. Disengage the 5 claws from the front side of the instrument panel and remove the instrument panel.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment