Ip

Antenna Chord Sub Assembly Camry

38. REMOVE POWER OUTLET SOCKET ASSEMBLY (See page OT-9)

39. REMOVE POWER OUTLET SOCKET COVER (See page OT-IO)

40. REMOVE OUTER MIRROR SWITCH ASSEMBLY

(a) Disengage the 2 claws and remove the outer mirror switch.

41. REMOVE LIGHT CONTROL RHEOSTAT

(a) Disengage the 2 claws and remove the light control rheostat.

42. REMOVE FRONT PANEL SEAL

(a) Remove the front panel seal.

43. REMOVE INSTRUMENT PANEL BOX SPRING

(a) Remove screw <A> and the instrument panel box spring.

44. REMOVE NO. 1 INSTRUMENT PANEL BOX

(a) Remove the 2 <A> screws and the instrument panel box.

45. REMOVE NO. 2 INSTRUMENT PANEL BOX

(a) Remove the 2 <A> screws and the instrument panel box.

46. REMOVE INSTRUMENT CLUSTER FINISH PANEL SEAL

(a) Disengage the 5 claws and remove the panel seal.

INSTALLATION

1. INSTALL INSTRUMENT CLUSTER FINISH PANEL SEAL

(a) Engage the 5 claws and install the panel seal.

2. INSTALL NO. 2 INSTRUMENT PANEL BOX

(a) Install the instrument panel box with the 2 <A> screws.

3. INSTALL NO. 1 INSTRUMENT PANEL BOX

(a) Install the instrument panel box with the 2 <A> screws.

4. INSTALL INSTRUMENT PANEL BOX SPRING

(a) Install the instrument panel box spring with screw <A>.

5. INSTALL FRONT PANEL SEAL

(a) Install the front panel seal.

6. INSTALL LIGHT CONTROL RHEOSTAT

(a) Engage the 2 claws and install the light control rheostat.

Rheostat Light Control

7. INSTALL OUTER MIRROR SWITCH ASSEMBLY

(a) Engage the 2 claws and install the outer mirror switch.

8. INSTALL POWER OUTLET SOCKET COVER (See page OT-IO)

9. INSTALL POWER OUTLET SOCKET ASSEMBLY (See page OT-IO)

B108232E01

10. INSTALL LOWER INSTRUMENT PANEL SUBASSEMBLY

(a) Using a nipper, cut off both ends of the runner portion shown in the illustration (When installing a new one).

(b) Apply butyl tape to install a new instrument panel pad lower onto the instrument panel lower (When installing a new one).

Adhesive:

Part No. 08850-00065, Butyl Tape Set or the equivalent

(c) Install the lower instrument panel with the 5 <D> bolts, 2 <E> bolts, screw <G> and screw <H>.

NOTICE:

Do not excessively tighten the <D> bolts, otherwise, it may damage the area not being tightened.

(d) Connect the clamps and connectors.

(e) Engage the 2 claws to connect the DLC3 connector.

11. CONNECT HOOD LOCK CONTROL LEVER SUBASSEMBLY

(a) Engage the 3 claws to connect the control lever.

12. CONNECT ANTENNA CORD SUB-ASSEMBLY

(a) Connect the 2 antenna cord clamps.

13. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY

(a) Engage the 4 claws and install the heater to register duct.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • mewael
    Where is fuse for power outlet socket toyota yaris mk2?
    8 years ago

Post a comment