Ip

REMOVAL

HINT:

Use the same procedure for both the RH and LH sides.

1. BOLTS, SCREWS AND NUTS TABLE

HINT:

All bolts, screws and nuts relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.

mm(in.) (L=Length)

Code

Shape

Code

Shape

Code

Shape

93568-15014

93568-55014

V-

90105-08120 91643-80820

B118994E01

B118994E01

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See page ME-145)

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See page ME-145)

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL (See page ME-145)

6. REMOVE COMBINATION METER ASSEMBLY (See page ME-146)

7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH (See page IR-50)

8. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH (See page IR-50)

9. REMOVE FRONT PILLAR GARNISH RH (See page IR-

10. REMOVE FRONT PILLAR GARNISH LH (See page IR-

REMOVE NO. 1 SWITCH HOLE BASE

(a) Disengage the 2 clips and 2 claws and remove the switch hole base.

(b) Pull the glove compartment door assembly out horizontally to disengage the hinge portion and remove the glove compartment door assembly. NOTICE:

Pull the glove compartment door out horizontally, otherwise, installation failure caused by excessive play around the hinge portion will result.

12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

(a) Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.

Parts Microscope Worksheet

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment