Ip

REMOVAL

HINT:

Use the same procedure for both the RH and LH sides.

1. BOLTS, SCREWS AND NUTS TABLE

HINT:

All bolts, screws and nuts relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.

Code

Shape

Code

Shape

Code

Shape

<A>

93568-15014

<B>

93568-55014

<C>

n \

JdJAl«

90105-08120

<D>

i

9=6

<E>

rf

9=6

<F>

9=6

WÊÊH L0=24 )

■■ti L0.164 )

■¡SB !Li;24 )

90159-60610

91635-60616

<G>

90159-50322

<H>

93568-15016

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See page ME-145)

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See page ME-145)

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL (See page ME-145)

6. REMOVE COMBINATION METER ASSEMBLY (See page ME-146)

7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER (See page AC-250)

8. REMOVE RADIO TUNER OPENING COVER (w/o Radio Receiver) (See page AC-125)

9. REMOVE RADIO RECEIVER ASSEMBLY (See page AV-44)

10. REMOVE AIR CONDITIONER PANEL SUBASSEMBLY (See page AC-250)

11. DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (See page AC-251)

12. DISCONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (See page AC-251)

13. DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (See page AC-251)

14. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH (See page IR-50)

15. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH (See page IR-50)

16. REMOVE FRONT PILLAR GARNISH RH (See page IR-

17. REMOVE FRONT PILLAR GARNISH LH (See page IR-

18. REMOVE NO. 1 SWITCH HOLE BASE (See page IP-20)

19. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (See page IP-20)

20. REMOVE UPPER INSTRUMENT PANEL SUBASSEMBLY (See page IP-21)

21. REMOVE FRONT DOOR SCUFF PLATE RH (See page IR-49)

22. REMOVE FRONT DOOR SCUFF PLATE LH (See page IR-49)

23. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH (See page IR-50)

24. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY LH (See page IR-50)

25. REMOVE COWL SIDE TRIM BOARD RH (See page IR-50)

26. REMOVE COWL SIDE TRIM BOARD LH (See page IR-50)

27. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

(a) Remove the shift lever knob.

28. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)

(a) Disengage the 6 claws and remove the shifting hole cover.

29. REMOVE CONSOLE BOX REAR COVER

(a) Disengage the 8 claws and remove the console box rear cover.

30. REMOVE CONSOLE BOX CARPET

(a) Remove the console box carpet.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment