Ir

REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page RS-1). NOTICE:

Always use "Torx" socket wrench E10 when removing the front seat.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

2. REMOVE FRONT SEAT HEADREST ASSEMBLY

HINT:

Use the same procedure for both sides. (a) Push in the lock button of the front seat headrest support and remove the front seat headrest.

3. REMOVE FRONT SEAT ASSEMBLY LH (See page SE-5)

4. REMOVE FRONT SEAT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

5. REMOVE REAR SEAT CUSHION COVER PAD SUBASSEMBLY

(a) for Fixed Seat Type:

(1) Remove the rear seat cushion cover pad subassembly (See page SE-106).

(b) for 60/40 Split Seat Type:

(1) Remove the rear seat cushion cover pad sub-assembly (See page SE-46).

6. REMOVE REAR SEATBACK ASSEMBLY RH (for 60/ 40 Split Seat Type) (See page SE-57)

7. REMOVE REAR SEATBACK ASSEMBLY LH (for 60/ 40 Split Seat Type) (See page SE-46)

8. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type) (See page SE-106)

9. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type) (See page ED-133)

10. REMOVE SPARE WHEEL COVER ASSEMBLY (for 60/ 40 Split Seat Type) (See page ED-133)

11. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type) (See page ED-134)

12. REMOVE FRONT DOOR SCUFF PLATE RH

(a) Disengage the 11 claws and remove the front door scuff plate.

13. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:

Use the same procedure as for the RH side.

14. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH

(a) Disengage the 4 claws and remove the instrument panel under cover.

15. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY LH

(a) Remove the 2 screws.

(b) Disengage the 3 claws and remove the instrument panel under cover.

16. REMOVE COWL SIDE TRIM BOARD RH

(a) Disengage the claw and the stud bolt and remove the cowl side trim board.

17. REMOVE COWL SIDE TRIM BOARD LH

HINT:

Use the same procedure as for the RH side.

18. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

(a) Remove the front door opening trim weatherstrip.

19. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Use the same procedure as for the RH side.

20. REMOVE REAR DOOR SCUFF PLATE RH

(a) Disengage the 7 claws and remove the rear door scuff plate.

21. REMOVE REAR DOOR SCUFF PLATE LH

HINT:

Use the same procedure as for the RH side.

22. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

(a) Remove the rear door opening trim weatherstrip.

23. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Use the same procedure as for the RH side.

24. REMOVE REAR SEAT SIDE COVER RH

(a) Disengage the 2 clips and the 4 claws and remove the rear seat side cover.

25. REMOVE REAR SEAT SIDE COVER LH

HINT:

Use the same procedure as for the RH side.

26. REMOVE ROOF SIDE INNER GARNISH RH

(a) w/ Curtain Shield Airbag: NOTICE:

Replace the special clip with a new one when the roof side inner garnish is removed.

(1) Disengage the 4 clips and the claw and remove the roof side inner garnish.

(b) w/o Curtain Shield Airbag:

(1) Disengage the 4 clips and the claw and remove the roof side inner garnish.

27. REMOVE ROOF SIDE INNER GARNISH LH

HINT:

Use the same procedure as for the RH side.

28. REMOVE CENTER PILLAR LOWER GARNISH RH

(a) Disengage the 3 claws and 2 clips and remove the center pillar lower garnish.

29. REMOVE CENTER PILLAR LOWER GARNISH LH

HINT:

Use the same procedure as for the RH side.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment