Li

(c) Inspect the turn signal switch. (1) Measure the resistance. Standard resistance

Tester Connection

Condition

Specified Condition

6 (TR) - 7 (E)

Right

Below 1 Q

6 (TR) - 7 (E)

Neutral

10 kQ or higher

5 (TL) - 7 (E)

Left

Below 1 Q

5 (TL) - 7 (E)

Neutral

10 kQ or higher

(d) Inspect the front fog light switch. (1) Measure the resistance. Standard resistance

Tester Connection

Condition

Specified Condition

3 (BFG) - 4 (LFG)

Front fog light switch ON

Below 1 Q

3 (BFG)- 4 (LFG)

Front fog light switch OFF

REPLACE HEADLIGHT DIMMER SWITCH

REPAIR OR REPLACE HARNESS OR CONNECTOR

Headlight Signal Circuit

DESCRIPTION

The headlights are illuminated when the light control switch, located on the headlight dimmer switch, is turned to the HEAD position.

For models with the H-LP/AMT relay (sedan models equipped with the daytime running light system and all hatchback models), refer to Headlight Relay Circuit (See page LI-28).

WIRING DIAGRAM

MAIN

Headlight Bulb LH

(llD Headlight Bulb RH

Headlight Dimmer Switch

B1

T1

RF

(H)

ED

Light Control Switch

OFF

Tail

O-

—O

Head

O-

—O

O-

—O-

HUT THL

HU

HL

(ED)

ED

Headlight

Dimmer

Switch

Flash

Low

o—

-o

High

O-

-o

INSPECTION PROCEDURE

INSPECT FUSE (H-LP RH/H-LP LO RH, H-LP LH/H-LP LO LH)

(a) Remove the H-LP RH/H-LP LO RH and H-LP LH/H-LP LO LH fuses from the engine room relay block.

(b) Measure the resistance. Standard resistance:

Below 1 Q

(c) Reinstall the H-LP RH/H-LP LO RH and H-LP LH/H-LP LO LH fuses.

REPLACE FUSE

INSPECT BULB (HEADLIGHT BULB)

Component Side:

Headlight Bulb*

1

—-2

^---

*: LH or RH

B129953E01

(a) Disconnect the B4 and B6 headlight connectors.

(b) Apply battery voltage to the terminals and check that the headlight illuminates.

Standard

Measurement Condition

Standard

Positive battery - Terminal 1 Negative battery - Terminal 3

Headlight illuminates (HI-Beam)

Positive battery - Terminal 2 Negative battery - Terminal 3

Headlight illuminates (LO-Beam)

(c) Reconnect the headlight connectors.

REPLACE BULB

CHECK HARNESS AND CONNECTOR (FUSE - HEADLIGHT)

Wire Harness Side:

Headlight Bulb Connector dD*2

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment