Removal

HINT:

• Use the same procedure for both the RH and LH sides.

• The procedure described below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE (for 5 Door) (See page IR-49)

3. REMOVE FRONT DOOR SCUFF PLATE (for 3 Door) (See page IR-97)

4. REMOVE REAR DOOR SCUFF PLATE (for 5 Door) (See page IR-51)

5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Remove the front door opening trim weatherstrip.

Dessin Des Tallon

6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP (for 5 Door)

(a) Remove the rear door opening trim weatherstrip.

7. REMOVE CENTER PILLAR GARNISH LOWER (for 5 Door) (See page IR-55)

Tester Connection

8. REMOVE FRONT DOOR COURTESY SWITCH

(a) Using "Torx" socket wrench T30, remove the screw.

(b) Disconnect the connector and remove the front door courtesy switch.

INSPECTION

1. INSPECT FRONT DOOR COURTESY SWITCH

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below. Standard Resistance

Tester Connection

1 - Switch body

1 - Switch body

Condition

ON (Shaft not pressed)

OFF (Shaft pressed)

Specified Condition

Below 1 Q

10 kQ or higher

If the result is not as specified, replace the front door courtesy switch.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment