Remove Yaris Front Wiper Arms

1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE HOOD SUB-ASSEMBLY

(a) Remove the 4 bolts and remove the hood.

4. REMOVE FRONT WIPER ARM HEAD CAP (See page WW-17)

5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See page WW-17)

6. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See page WW-17)

7. REMOVE HOOD TO COWL TOP SEAL (See page WW-18)

8. REMOVE COWL TOP VENTILATOR LOUVER SUBASSEMBLY (See page WW-18)

9. REMOVE COWL TOP VENTILATOR LOUVER LH (See page WW-18)

10. REMOVE WINDSHIELD WIPER MOTOR AND LINK (See page WW-19)

11. REMOVE COWL TO REGISTER DUCT SUBASSEMBLY (See page EM-122)

12. REMOVE COWL TOP PANEL OUTER (See page EM-123)

13. REMOVE COLUMN HOLE COVER SILENCER SHEET

(a) Remove the floor carpet and 2 clips and remove the column hole cover silencer.

How Remove Cowl Panel Rav4

14. REMOVE STEERING SLIDING YOKE SUBASSEMBLY

(a) Use a seat belt to fix the steering wheel assembly, in order to avoid breakage of the spiral cable.

1991 Mr2 Speedometer Subassembly

(b) Place the matchmarks on the sliding yoke of the steering intermediate shaft assembly and the power steering.

(c) Loosen bolt A, remove bolt B and separate the steering intermediate shaft assembly

Sheet Column Hole Cover Silencer

15. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

(a) Remove clip A, separate clip B from the body and separate No. 1 steering column hole cover sub-assembly. NOTICE:

Do not damage clip B.

16. REMOVE FRONT WHEEL

17. REMOVE TIE ROD END SUB-ASSEMBLY (See page DS-3)

18. REMOVE TIE ROD END SUB-ASSEMBLY

HINT:

Use the same procedure for the RH side as for the LH side.

19. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (See page DS-4)

20. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.

21. REMOVE FRONT SUSPENSION LOWER ARM LH (See page DS-4)

22. REMOVE FRONT SUSPENSION LOWER ARM RH

HINT:

Use the same procedure for the RH side as for the LH side.

23. SUSPEND ENGINE ASSEMBLY

(1) Remove the bolt and remove the radio setting condenser.

(2) Remove the bolt and remove the air-fuel ratio sensor wiring bracket.

(3) Install the engine hanger with the bolt in the position shown in the illustration.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • luciana davide
    How to remove yaris louver?
    8 years ago
  • AALIYAH
    How remove cowl panel rav4?
    8 years ago
  • SVEN
    How to remove 09 yaris front wiper?
    8 years ago
  • Thomas Hardy
    How to remove toyota yaris wipers?
    8 years ago
  • david
    How to remove toyota yaris windshield wiper?
    8 years ago

Post a comment