Remove Room Light Assembly

(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light lens.

(b) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.

HINT:

Use the same procedure for both sides.

(c) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light.

(d) Remove the roof wire from the claw of the room light.

(e) Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and disconnect the room light switch base.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment