Blower Resistor Components

Carina Blower ResistorResistor Blower CarinaToyota Celica 2004 Blower Sensor

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH (for Hatchback) (See page IR-50)

3. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH (for Sedan) (See page IR-14)

4. REMOVE BLOWER RESISTOR

(a) Pull back the floor carpet.

|_| E032877E03

(b) Disconnect the connector.

(c) Remove the 2 screws and the blower resistor.

INSPECTION

1. INSPECT BLOWER RESISTOR

(a) Measure the resistance. Standard resistance

Tester Connection

Specified Condition

1 - 4

3.12 to 3.60 Q

3 - 4

1.45 to 1.67 Q

2 - 4

0.52 to 0.60 Q

If the resistance value is not as specified, replace the blower resistor.

INSTALLATION

1. INSTALL BLOWER RESISTOR

(a) Install the blower resistor with the 2 screws.

(b) Connect the connector.

\ \

\

VTÍE^T-^—

" \

0

}

I101557

(c) Install the floor carpet.

2. INSTALL INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH (for Hatchback) (See page IR-81)

3. INSTALL INSTRUMENT PANEL UNDER COVER SUBASSEMBLY RH (for Sedan) (See page IR-35)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

AIR CONDITIONING - COMPRESSOR AND PULLEY (for 1NZ-FE)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • SANDRA BONA
    How to repair corolla blower resistor?
    8 years ago
  • Antti
    What is the resistance of camry 1989 blower resistor?
    7 years ago

Post a comment