Body Panel Antirust Agent Wax Application Areas

HINT:

1) Apply anti-rust agent (wax) around the hinges whenever adjusting the doors and hoods.

2) Even if partially repairing a part, apply anti-rust agent (wax) over the entire application area of the part.

3) Wipe off the anti-rust agent immediately with a rag soaked in silicone remover if it is accidentally applied to other areas.

F23344

BODY PANEL ANTI-CHIPPING PAINT APPLICATION AREAS

HINT:

1) Anti-chipping paint should be applied to some areas before the second coat and to other areas after the top coat.

2) Wipe off the paint immediately with a rag soaked in silicone remover if unrelated areas are accidentally coated.

Soft-Chip (Poly Olefine)

F23342

Two-dimensional distance

Center-to-center horizontal distance in forward/ rearward direction

GENERAL INFORMATION

1. BASIC DIMENSIONS

(a) There are two types of dimensions in the diagram.

(1) (Three-dimensional distance)

^ Straight-line distance between the centers of two measuring points.

Two-dimensional distance

Center-to-center horizontal distance in forward/ rearward direction

Vertical distance to center

Vertical distance to lower surface

Imaginary Standard Line

Imaginary Standard Line

Shurflo Pump Positive Wires

(2) (Two-dimensional distance)

^ Horizontal distance in forward/rearward direction between the centers of two measuring points.

^ The height from an imaginary standard line.

(b) In cases in which only one dimension is given, left and right are symmetrical.

(c) The dimensions in the following drawing indicate actual distance. Therefore, please use the dimensions as a reference.

(d) The line that connects the places listed below is the imaginary standard line when measuring the height. (The dimensions are printed in the text.)

SYMBOL

Name

1

The place that was lowered A mm from the under surface of the rocker panel centered on the front jack up point.

2

The place that was lowered B mm from the under surface of the rocker panel centered between 1 and 3.

3

The place that was lowered C mm from the under surface of the rocker panel centered on the rear jack up point.

Plate Looseness

Plate Looseness

2. MEASURING

(a) Basically, all measurements are to be done with a tracking gauge. For portions where it is not possible to use a tracking gauge, a tape measure should be used.

(b) Use only a tracking gauge that has no looseness in the body, measuring plate, or pointers.

HINT:

1) The height of the left and right pointers must be equal.

2) Always calibrate the tracking gauge before measuring or after adjusting the pointer height

3) Take care not to drop the tracking gauge or otherwise shock it

4) Confirm that the pointers are securely in the holes.

(c) When using a tape measure, avoid twists and bends in the tape.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment