Body Panel Replacement In This Manual

BODY PANEL REPLACEMENT

BODY PANEL REPLACEMENT

Cuting Yaris

POINT

1. Remove the [A] at the same time. PART NAME [A] Fuel filler opening lid 200 mm (7.87 in.)

POINT

1. Remove the [A] at the same time. PART NAME [A] Fuel filler opening lid 200 mm (7.87 in.)

(A) : REPLACEMENT PART AND METHOD QUARTER PANEL (CUT)

Replacement method (ASSY)...Assembly replacement (CUT)...Major cutting (less than 1/2 of part used) (CUT-H)...Half cutting (about 1/2 of part used) (CUT-P)...Partial cutting (most of part used) Replacement part

(D : REMOVAL CONDITIONS © : PART LOCATION REMOVAL DIAGRAM

Describes in detail the removal of the damaged part involving repair by cutting. REMOVAL GUIDE

Provides additional information to more efficiently help you perform the removal.

F13890A

INSTALLATION

■ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)

■ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish. After welding, apply the polyurethane foam to the corresponding parts.

■ After welding, apply body sealer and under-coating to the corresponding parts.

■ After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.

Temporary Body Panel Repair

POINT

1. Before temporarily installing the new parts, apply sealer to the wheel arch. HINT

1) Apply body sealer about 5 mm (0.20 in.) front the flange, avoiding any oozing.

2) Apply sealer evenly, about 3-4 mm (0.12-0.16 in.) in diameter

3) For other sealing points, refer to section PC.

POINT

1. Before temporarily installing the new parts, apply sealer to the wheel arch. HINT

1) Apply body sealer about 5 mm (0.20 in.) front the flange, avoiding any oozing.

2) Apply sealer evenly, about 3-4 mm (0.12-0.16 in.) in diameter

3) For other sealing points, refer to section PC.

(F) : INSTALLATION CONDITIONS INSTALLATION DIAGRAM

Describes in detail the installation of the new parts involving repair by welding and/or cutting, but excluding painting. INSTALLATION GUIDE

Provides additional information to more efficiently help you perform the installation.

CO : INSTALLATION OF WELD POINTS

Weld method and panel position symbols (See page IN-9)

PART NAME

F13891A

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment