Check Harness And Connector Door Control Receiver Main Body

Wire Harness Side:

Main Body ECU Connector

RDA Front View PRG

RDA Front View PRG

Door Control Receiver Connector

1

2

3

4

(a) Disconnect the D33 main body ECU connector.

(b) Disconnect the J13 door control receiver connector.

(c) Measure the resistance. Standard resistance

Tester Connection

Specified Condition

D33-16 (RDA) - J13-2 (RDA)

Below 1 Q

D33-16 (RDA) - Body ground

10 kQ or higher

D33-17 (PRG) - J13-3 (PRG)

Below 1 Q

D33-17 (PRG) - Body ground

10 kQ or higher

(d) Reconnect the main body ECU connector.

(e) Reconnect the door control receiver connector.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment