Dl

INSPECTION PROCEDURE

INSPECT FRONT DOOR LOCK ASSEMBLY LH

Front Door Lock Measurement

(a) Apply the battery voltage to the door lock motor and measure the resistance. Standard resistance

Tester Connection

Condition

Specified Condition

8 (LSSR) - 7 (E)

Terminal 1 Battery negative(-) ^ Terminal 4

Below 1 q

8 (LSSR) - 7 (E)

Terminal 4 Battery negative(-) ^ Terminal 1

10 kq or higher

REPLACE FRONT DOOR LOCK ASSEMBLY LH

CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT DOOR LOCK ASSEMBLY LH)

Wire Harness Side:

Main Body ECU Connector

10 11 12

Front View

'LSWD

Front Door Lock Assembly LH Connector

1

2

3

4

5

6

7

8

9

Front View

LSSR

(a) Disconnect the D33main body ECU connector.

(b) Disconnect the G5 door lock connector.

(c) Measure the resistance. Standard resistance

Tester Connection

Specified Condition

D33-21 (LSWD) - G5-8 (LSSR)

Below 1 q

D33-21 (LSWD) or G5-8 (LSSR) -Body ground

10 kq or higher

(d) Reconnect the main body ECU connector.

(e) Reconnect the door lock connector.

REPAIR OR REPLACE HARNESS OR CONNECTOR

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment