Failsafe Chart

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition

Auto Cancel Condition

Re-operation Condition

CRUISE main indicator light blinks

• There is open or short in stop light switch circuit

• There is problem with vehicle speed signal

• There is problem with throttle position sensor and motor

Turn cruise control main switch on again

CRUISE main indicator light blinks

• There is problem with input circuit of stop light switch circuit

• There is problem with cancel circuit

• Turn cruise control main switch on again

• Turn engine switch off then on again

CRUISE main indicator light remains on (Cruise control is canceled)

• Vehicle speed is lower than low speed limit (approximately 25 km/h (40 mph)) while running with cruise control on

Push cruise control main switch to + (ACCEL)/RES (RESUME)

• Vehicle speed is lower than stored speed by approximately 10 km/h (16 mph) or more

Push cruise control main switch to - (COAST)/ SET

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment