Front Body Pillar Cut Sedan

REPLACEMENT

With the cowl top side upper panel removed.

REMOVAL

Frontal Cut Organ

POINT

1 After removing [A], remove the front body pillar.

2 *1 : This part of the outer panel is reused because the rocker panel section is cut off at a position behind the service part cut position of the outer panel.

PART NAME

[A] Front Panel No.1 Bracket

Frontal Cut Organ

INSTALLATION

^ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)

^ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

^ After welding, apply polyurethane foam to the corresponding parts.

^ After welding, apply body sealer and undercoating to the corresponding parts.

^ After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

200 mm

200 mm

(10 mmx3)
□ -2

POINT

1 Before temporarily installing the new parts, weld [B], [C], [D] and [E] with standard welding number. PART NAME

[B] Rocker Outer Reinforce [C] Front Body Pillar Lower Reinforce [D] Front Body Inner Pillar [E] Front Body Upper Outer Pillar

10 mm (0.39 in.) 15 mm (0.59 in.) 200 mm (7.87 in.)

Frontal Cut Organ
[A]

F24827-1

POINT

1 Inspect the fitting of the front fender, front door, window shield glass and other related parts before welding as this affects the appearance of the finish.

2 After installing the new parts, install [A]

PART NAME

[A] Front Panel No.1 Bracket

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment