Front Door Outer Panel Cut Sedan Ex Usa Canada

REPLACEMENT

REMOVAL

Hemming Location

Disc Sander

Electrical Schematic Yaris 2001

Disc Sander

POINT

F24875

INSTALLATION

^ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)

^ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

^ After welding, apply polyurethane foam to the corresponding parts.

^ After welding, apply body sealer and undercoating to the corresponding parts.

^ After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

Front Door Shuto Guripu

POINT

POINT

Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

HINT:

1) Apply sealer evenly of about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.

Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool. HINT:

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment