Inspection

1. INSPECT OUTPUT SHAFT

(a) Using a dial gauge and 2 V-blocks, check the output shaft runout. Maximum runout: 0.015 mm (0.0006 in.)

If the runout exceeds the maximum, replace the output shaft.

(b) Using a micrometer, measure the outer diameter of the output shaft journal surface, at the locations indicated.

Standard outer diameter: Part A:

If the outer diameters are less than the minimums, replace the output shaft.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment