Inspection Procedure

NOTICE:

• Turn the ignition switch OFF before measuring the resistances of the CAN main wire and the CAN branch wire.

• After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.

Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open. HINT:

Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

INSPECT ECM POWER SOURCE CIRCUIT

(a) Inspect the power source circuit (See page ES-352).

GO TO POWER SOURCE CIRCUIT

REPLACE ECM

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment