Inspection Procedure

INSPECT FUSE (ACC, AMI, DOME)

(a) Remove the ACC fuse and AMI fuse from the main body ECU.

(b) Remove the DOME fuse from the engine room R/B.

(c) Measure the resistance of the fuses. Standard resistance: Below 1 Q

REPLACE FUSE

CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)

(a) Disconnect the D10 receiver connector.

(b) Measure the voltage. Standard voltage

Tester Connection

Condition

Specified Condition

D10-4 (B) - Body ground

Always

11 to 14 V

D10-3 (ACC) - Body ground

Ignition switch ACC

11 to 14 V

(c) Measure the resistance. Standard resistance

Tester Connection

Specified Condition

D10-7 (GND) - Body ground

Below 1 Q

REPAIR OR REPLACE HARNESS OR CONNECTOR

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment