Inspection

1. INSPECT INPUT SHAFT

(a) Using a dial gauge, check the input shaft runout. Maximum runout: 0.015 mm (0.0006 in.)

If the runout exceeds the maximum, replace the input shaft.

(b) Using a micrometer, measure the outer diameter of the input shaft journal surface, at the locations indicated.

Standard outer diameter: Part A:

24.985 to 25.000 mm (0.9836 to 0.9842 in.) Minimum outer diameter: Part A:

30.985 mm (1.2198 in.) Part D: 24.985 mm (0.9836 in.)

If the outer diameters are less than the minimums, replace the input shaft.

2. INSPECT 4TH GEAR

(a) Using a cylinder gauge, measure the inside diameter of the 4th gear. Standard inside diameter:

34.015 to 34.031 mm (1.3391 to 1.3398 in.) Maximum inside diameter:

34.031 mm (1.3398 in.) If the inside diameter exceeds the maximum, replace the 4th gear.

3. INSPECT 3RD GEAR

(a) Using a cylinder gauge, measure the inside diameter of the 3rd gear. Standard inside diameter:

36.015 to 36.031 mm (1.4179 to 1.4185 in.) Maximum inside diameter:

36.031 mm (1.4185 in.) If the inside diameter exceeds the maximum, replace the 3rd gear.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment