Yaris Simple Battery Bracket Install

1. INSTALL MANUAL TRANSAXLE ASSEMBLY

(a) Align the input shaft with the clutch disc and install the manual transaxle onto the engine.

(b) Install the 7 bolts.

2. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING BRACKET

(a) Install the engine mounting bracket LH with the 4 bolts.

3. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR

(a) Install the engine mounting insulator LH with the 5 bolts.

(b) Install the engine mounting bracket LH and engine insulator LH with the bolt and nut.

4. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING CONTROL BRACKET

(a) Install the engine mounting control bracket with the 4 bolts.

5. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (See page PS-77)

6. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (See page DS-13)

7. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See page DS-14)

8. INSTALL FRONT AXLE ASSEMBLY LH

9. INSTALL FRONT AXLE ASSEMBLY RH (See page DS-14)

10. INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See page DS-14)

11. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

The installation procedure for the RH side is the same as that for the LH side.

12. INSTALL TIE ROD END SUB-ASSEMBLY LH (See page DS-15)

13. INSTALL TIE ROD END SUB-ASSEMBLY RH

HINT:

The installation procedure for the RH side is the same as that for the LH side.

14. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH (See page DS-14)

15. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 RH

HINT:

The installation procedure for the RH side is the same as that for the LH side.

16. INSTALL SPEED SENSOR FRONT LH (w/ ABS) (See page DS-15)

17. INSTALL SPEED SENSOR FRONT RH (w/ ABS)

HINT:

The installation procedure for the RH side is the same as that for the LH side.

18. INSTALL FRONT AXLE HUB LH NUT (See page DS-15)

19. INSTALL FRONT AXLE HUB RH NUT

HINT:

The installation procedure for the RH side is the same as that for the LH side.

20. INSTALL STARTER ASSEMBLY (See page ST-17)

21. CONNECT CONNECTOR

(a) Connect the back-up light switch connector.

22. CONNECT WIRE HARNESS

(a) Connect the wire harness with the bolt. Torque: 26 N*m (260 kgf*cm, 19 ft.*lbf)

23. INSTALL CONTROL CABLE BRACKET

(a) Install the control cable bracket with the 2 bolts. Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)

24. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the 2 cable ends and install the 2 washers and the 2 clips.

(b) Install 2 new clips onto the control cable bracket.

25. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

(a) Install the clutch release cylinder and clutch pipe with the 4 bolts.

Torque: 12 N*m (120 kgf*cm, 8.7 ft.*lbf) for bolt A

w

V

kJ^-Ik vkx(

Y

C106369

26. INSTALL BATTERY CARRIER

(a) Install the battery carrier with the 5 bolts. Torque: 17 N*m (175 kgf*cm, 13 ft.*lbf)

27. INSTALL BATTERY TRAY

28. INSTALL BATTERY

29. INSTALL BATTERY CLAMP SUB-ASSEMBLY

30. INSTALL AIR CLEANER BRACKET

(a) Install the air cleaner bracket with the 2 bolts.

31. INSTALL AIR CLEANER ASSEMBLY (See page EM-146)

32. INSTALL CYLINDER HEAD COVER NO.2 (See page IG-10)

33. INSTALL COWL TOP PANEL OUTER (for Hatchback) (See page EM-146)

34. INSTALL COWL TO REGISTER DUCT SUBASSEMBLY NO.2 (for Hatchback) (See page EM-147)

35. INSTALL WINDSHIELD WIPER MOTOR AND LINK (for Hatchback) (See page WW-21)

36. INSTALL COWL TOP VENTILATOR LOUVER LH (for Hatchback) (See page WW-21)

37. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for Hatchback) (See page WW-21)

38. INSTALL COWL TOP PANEL OUTER (for Sedan) (See page EM-147)

39. INSTALL FRONT AIR SHUTTER SEAL (for Sedan) (See page EM-148)

40. INSTALL WINDSHIELD WIPER MOTOR AND LINK (for Sedan) (See page WW-12)

41. INSTALL COWL TOP VENTILATOR LOUVER SUBASSEMBLY (for Sedan) (See page WW-12)

42. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY RH (for Sedan) (See page WW-13)

43. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY LH (for Sedan) (See page WW-13)

44. INSTALL HOOD TO COWL TOP SEAL (See page WW-22)

45. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See page WW-22)

46. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See page WW-23)

47. INSTALL HOOD SUB-ASSEMBLY

48. INSPECT HOOD SUB-ASSEMBLY (See page ED-3)

49. ADJUST HOOD SUB-ASSEMBLY (See page ED-4)

50. ADD TRANSAXLE OIL

51. INSPECT AND ADJUST TRANSAXLE OIL (See page MX-2)

52. INSTALL ENGINE UNDER COVER RH

53. INSTALL ENGINE UNDER COVER LH

54. INSTALL FRONT WHEELS

55. INSTALL STEERING SLIDE YOKE SUB-ASSEMBLY (See page PS-79)

56. INSTALL COLUMN HOLE COVER SILENCER SHEET (See page PS-79)

57. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

58. INSPECT ABS SPEED SENSOR SIGNAL (w/ ABS)

59. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

60. CHECK FOR EXHAUST GAS LEAKAGE

61. CHECK FOR TRANSAXLE OIL LEAKAGE

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment