Installation

1. INSTALL CLUTCH PEDAL NO.1 CUSHION

(a) Install the clutch pedal No. 1 cushion onto the clutch pedal.

2. INSTALL CLUTCH PEDAL BUSH

(a) Apply MP grease to the 2 bushes and collar.

(b) Install the 2 bushes and collar onto the clutch pedal.

3. INSTALL CLUTCH PEDAL PAD

4. INSTALL CLUTCH PEDAL SUB-ASSEMBLY

(a) Install the clutch pedal onto the clutch pedal support with the bolt and the nut. Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)

HINT:

Install the bolt from the left side of the vehicle.

5. INSTALL CLUTCH PEDAL SPRING

6. INSTALL CLUTCH PEDAL STOPPER BOLT

(a) Install the clutch pedal stopper bolt so that its end touches the clutch pedal cushion. HINT:

Tighten the lock nut to the specified torque when adjusting the clutch pedal.

7. INSTALL CLUTCH START SWITCH ASSEMBLY

(a) Install the clutch start switch with the nut. Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf)

8. INSTALL CLUTCH PEDAL SUPPORT SUBASSEMBLY

(a) Install the clutch pedal support onto the vehicle with the bolt.

(b) Connect the clutch start switch connector.

(c) Connect the wire harness clamp.

9. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY (See page CL-10)

10. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE (See page CL-10)

11. INSTALL CLUTCH RESERVOIR TUBE (See page CL-10)

12. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER (for Hatchback)

13. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER (for Sedan)

14. INSTALL BRAKE BOOSTER ASSEMBLY

15. INSPECT AND ADJUST CLUTCH PEDAL SUBASSEMBLY (See page CL-3)

16. INSTALL INSTRUMENT PANEL UNDER COVER SUBASSEMBLY NO.1 (See page IR-82)

CLUTCH MASTER CYLINDER COMPONENTS

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment