Installation

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the control cable with the 3 nuts. Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

(b) Install the control shift cable onto the shift lever retainer.

NOTICE:

• Install the cable with the protruding portion of the cable outer facing upward.

• After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.

(c) Connect the control shift cable to the shift lever.

(d) Install the control shift cable onto the control cable bracket with a new clip.

(e) Connect the control shift cable to the transaxle through the washer.

(f) Install the control select cable onto the shift lever retainer.

NOTICE:

• Install the cable with the protruding portion of the cable outer facing upward.

• After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.

Cover

Lock Piece

Adjuster Case

[fei

C108468E02

(g) Connect the control select cable to the shift lever with the clip.

NOTICE:

• Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.

• Insert the clip in the direction shown in the illustration.

(h) Install the control select cable onto the control cable bracket with a new clip.

(i) Connect the control select cable to the transaxle through the washer.

(j) Adjust the length of the control select cable.

(1) Slide the adjuster case cover in the direction shown in the illustration (Illustration A).

(2) Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

(3) Press the lock piece into the adjuster case and lock it (Illustration B).

(4) Slide the cover in the direction shown in the illustration (Illustration C).

NOTICE:

Slide the cover past the protrusion portion of the lock piece (Illustration D).

2. INSTALL FRONT FLOOR HEAT INSULATOR NO.1

(a) Install floor heat insulator No. 1 with the 2 bolts and nut.

3. INSTALL EXHAUST PIPE ASSEMBLY FRONT (See page EX-8)

4. CONNECT OXYGEN SENSOR CONNECTOR

5. INSTALL CONSOLE BOX ASSEMBLY REAR (for Hatchback) (See page IP-79)

6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Hatchback) (See page IP-80)

7. INSTALL REAR CONSOLE BOX ASSEMBLY (for Sedan) (See page IP-88)

8. INSTALL CONSOLE BOX CARPET (for Sedan) (See page IP-88)

9. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan) (See page IP-89)

10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See page IP-89)

11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Sedan) (See page IP-89)

12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan) (See page ME-142)

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

MANUAL TRANSAXLE ASSEMBLY COMPONENTS

for Hatchback:

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment