Installation

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page RS-1). NOTICE:

Always use "Torx" socket wrench E10 when installing the rear seat.

INSTALL ANTENNA CORD SUB-ASSEMBLY

(a) w/ Curtain Shield Airbag:

(1) Install the part of the antenna cord marked with red positioning tape into claw A of the front side rail spacer.

(2) Install the antenna cord positioning tapes into the 2 claws of the front and rear side rail spacers.

(3) Insert the antenna cord positioning tape into the cutout of the roof headlining.

(4) Align the locating tapes on the antenna cord with the markings on the roof headlining.

(5) Install the antenna cord onto the roof headlining with 6 new pieces of tape.

Tape size:

NOTICE:

• Apply the tape securely in place.

• Do not touch the adhesive surface when applying the tape to prevent adhesion failure.

(b) w/o Curtain Shield Airbag:

(1) Install the part of the antenna cord marked with red positioning tape into claw A of the front side rail spacer.

Mark

Measurement

a

80 mm (3.15 in.)

b

20 mm (0.787 in.)

(2) Install the antenna cord positioning tapes into the 4 claws of the front and rear side rail spacers.

(3) Insert the antenna cord positioning tape into the cutout of the roof headlining.

(4) Align the locating tapes on the antenna cord with the markings on the roof headlining.

(5) Install the antenna cord onto the roof headlining with 4 new pieces of tape.

Recondition Recycle

Positioning Tape k

Cutout

Marking

Positioning Tape k

Cutout

Marking

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment