Installation

1. INSTALL RADIO RECEIVER ASSEMBLY

(a) for Integrated with Panel:

(1) Connect the plug.

(2) Connect the 3 radio connectors.

(3) Align the 2 bosses of the instrument panel with the hole in the radio bracket.

(4) Engage the 4 clips and 4 claws and install the radio receiver.

(5) Tighten the 4 bolts.

(6) Connect the hazard warning signal switch connector.

(b) except Integrated with Panel:

(1) Connect the plug.

(2) Connect the 2 radio connectors.

(3) Align the 2 bosses of the instrument panel with the hole in the radio bracket.

(4) Install the radio receiver with the 4 bolts.

2. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (except Integrated with Panel) (See page IP-56)

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL (See page ME-140)

4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See page ME-141)

5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See page ME-141)

6. INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See page ME-142)

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment