Installation

1. INSTALL HEATER BLOWER MOTOR RELAY

(a) Install the heater blower motor relay.

2. INSTALL INSTRUMENT PANEL BOX (for Hatchback) (See page IP-78)

3. INSTALL INSTRUMENT PANEL BOX (for Sedan) (See page IP-53)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PTC HEATER RELAY ON-VEHICLE INSPECTION

1. INSPECT PTC HEATER RELAY

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance between the terminals. Standard resistance

Tester Connection

Specified Condition

3 - 5

10 kQ or higher

3 - 5

Below 1 Q (When battery voltage applied to terminals 1 and 2)

If the result is not as specified, replace the PTC heater relay.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment